Service requests: doing the repair
What to do when SureBright sends you a repair job on a system you installed: respond in time, send an estimate, do the work once it is approved, and close the job so you can be paid.
Use this page when a service request arrives. You decide whether to take the job, tell SureBright what the repair will take, do the work once it is approved, and close the job with a report. Closing the job is what lets you invoice for it.
Why you received a service request#
A claim on a plan you sold was approved. As the original installer you have the first right to do the repair, and you are paid for the work.
New requests appear under Service in the New Request tab, and SureBright also emails you. Open a request to see the customer, the affected products, the issue and the time you have left to respond.
Respond within 24 hours#
You have 24 hours from when the request is sent. The request shows the time remaining.
If you do not respond in time, the request is rejected automatically and goes to the next qualified technician in SureBright's network. Your customer is still looked after, but the paid work goes to someone else.
Where a job sits at each stage#
Accept the job and send an estimate#
Accept the request
Select Accept. The portal asks Has the unit been inspected on site?
Yes, inspected: describe the service needed and say when you can complete the job.
Not yet: say when you will visit the customer. After the visit, open the job and select Add inspection details.
Build the estimate
Select Submit estimate and fill in:
Labor cost: the hours the repair will take and your repair team size. The hourly rate is fixed and already shown, so you do not enter it.
Add part: each part that needs replacing, with its name, quantity and cost. List parts at your own cost. The hint beside Cost (Per unit) tells you how to work out the figure to enter.
Photos or documents that support the estimate: up to 5 files, PDF, PNG or JPEG, 5 MB each.
Wait for approval
The job shows Under review until SureBright approves the estimate. Some estimates are approved straight away. If an estimate is sent back, update it and submit it again.
Do not start work before the estimate is approved. Work done before approval is not paid.
If you cannot source a part, say so, and SureBright arranges it. If the manufacturer supplies the part under its warranty, your estimate covers the labour only.
When the job changes#
Close the job with a report#
When the repair is finished, select Mark job as done. This is your closing report. Check the labour time, team size and parts used against the work you did, use Edit estimation to correct them, attach your invoice or receipt for the parts, add a note and select Submit. The report has to match the approved estimate and any additional authorisation you were given.
SureBright reviews the report. Once it is approved, the job appears under Invoices ready to be invoiced. See Getting paid, and what you are charged.
Decline a request#
Select Reject, choose the reason and add a note.
If you have already visited the site, send SureBright your assessment with the rejection. SureBright uses it to route the job and to review payment for the visit.
You can refer another installer. Give the company name, contact name, email, phone and address.
The repair is then done by the installer you referred or by a qualified technician from SureBright's network. Your customer is told who is handling it.